E 150 V8-4.6L SOHC VIN W (2004)
3. Start the caliper locking pin in the caliper locking groove.
4. Using the Brake Caliper Pin Remover, drive the caliper locking pin into the caliper locking groove until the retention tabs emerge.
5. Repeat for the other caliper locking pin.
6. Using new copper washers, install the brake hose flow bolt.
7. Install the tire and wheel assembly.
8. Lower the vehicle.
9. Check and, if necessary, fill the brake master cylinder reservoir.
10. Bleed the brake system.
Caliper Disassembly and Assembly
Brake Caliper
Material
Disassembly
NOTE: Dual piston calipers shown, single piston caliper similar.
1. Remove the rear disc brake caliper.
2. Drain the remaining brake fluid from the disc brake caliper.
