E 150 V8-4.6L SOHC VIN W (2004)
7. After the torque converter has drained, install a new drain plug.
8. Install the torque converter drain plug cover.
9. Install the drain plug.
10. CAUTION: The use of any other fluids than specified can result in the transmission failing to operate in a normal manner or transmission failure.
Fill the transmission.
^
Add 6.2 liters (6.5 qts) of clean automatic transmission fluid to the transmission through the fluid filler tube.
11. Start the engine. Move the transmission range selector lever through all the gear ranges, checking for engagements.
12. With the engine running and the transmission at normal operating temperature 66-77°C (150-170°F), check and adjust the transmission fluid level,
and check for any leaks. If fluid is needed, add fluid in increments of 0.24-liter (0.5-pint) until the correct level is achieved (fluid should be in the
cross-hatched area of the fluid level indicator).
Vehicles not equipped with a fluid pan or a torque converter drain plug
Draining
1. With the vehicle in NEUTRAL, position on a hoist.
2. NOTE: Do not discard the fluid pan gasket unless damaged. This is a reusable gasket.
Remove the transmission fluid pan and gasket.
1. Loosen, but do not remove the bolts.
2. Remove the front and side bolts.
3. Lower the front of the fluid pan and allow the fluid to drain.
4. Remove the remaining fluid pan bolts and the fluid pan.
3. Do not remove or install a new fluid filter.
4. NOTE: If equipped with a radiator in-tank transmission fluid cooler or an auxiliary cooler, the coolers will need to be flushed.
