E 150 V8-4.6L SOHC VIN W (2004)
2.
Install the ABS Module heat shield as follows:
a)
Clean the top of the ABS module with the alcohol pad provided in the service kit.
b)
Hold the radiator coolant reservoir hose out of the way.
c)
Position the heat shield so it will fit securely against the connector side of the module, set the retaining hooks under the lip of the rear side of
the module, then rotate the shield downward to snap it into place. See Figure 4.
3.
If disconnected, reconnect the speed control deactivation switch.
4.
Close the hood.
HEAT SHIELD INSTALLATION - VEHICLES WITH HYDRO-BOOST
NOTE:
To install the heat shield on vehicles with Hydro-boost, the ABS module must be removed from the HCU due to lack of clearance between the
module and the brake master cylinder.
1.
Remove the coolant recovery reservoir retaining screws.
2.
If required for access to the ABS module, remove the air cleaner assembly.
3.
Disconnect the module wire harness connector by releasing the lock tab and pulling the connector from the module. See Figure 5.
