ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Seat Belt Tensioner|Removal and Installation|Page 7615 > < Safety Belt System|Page 7612
Page 1
background image

Seat Belt Tensioner: Service and Repair
Removal and Installation

SAFETY BELT BUCKLE AND PRETENSIONER

Special Tool(s)

SPECIAL TOOL(S)

REMOVAL

WARNING:

-

The safety belt pretensioner is a pyrotechnic device. Always wear safety glasses when repairing an air bag equipped vehicle and when
handling a safety belt buckle pretensioner or safety belt retractor pretensioner. Never probe a pretensioner electrical connector. Doing so
could result in pretensioner or air bag deployment and could result in personal injury.

-

The restraint system diagnostic tool is for restraint system service only. Remove from vehicle prior to road use. Failure to remove could
result in injury and possible violation of vehicle safety standards.

NOTE:

-

If a seat equipped with a seat mounted side air bag and/or a safety belt pretensioner (if equipped) system is being serviced, the air bag system must
be deactivated.

-

The SRS must be fully operational and free of faults before releasing the vehicle to the customer.

-

Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic
procedure again.

-

The driver seat is shown unless otherwise noted.

All vehicles

1. WARNING:  To avoid accidental deployment and possible personal injury, the backup power supply must be depleted before repairing

or replacing any front or side air bag supplemental restraint system (SRS) components and before servicing, replacing, adjusting or
striking components near the front or side air bag sensors, such as doors, instrument panel, console, door latches, strikers, seats and hood
latches.

Please refer to the appropriate vehicle system to determine location of the front air bag sensors.

To deplete the backup power supply energy, disconnect the battery ground cable and wait at least one minute. Be sure to disconnect the
auxiliary batteries and power supplies (if equipped).

Disconnect the battery ground cable(s).

2. WARNING:  To reduce the risk of serious personal injury, read and follow all warnings, cautions, notes, and instructions in the

supplemental restraint system (SRS) deactivation/reactivation procedure.

Deactivate the supplemental restraint system (SRS).

3. WARNING:  To reduce the risk of serious personal injury, read and follow all warnings, cautions, notes, and instructions in the seat

removal and installation procedure.

Seat Belt Tensioner|Removal and Installation|Page 7615 > < Safety Belt System|Page 7612