E 150 V8-4.6L SOHC VIN W (2004)
Turn Signal Switch: Service and Repair
Multifunction Switch
Removal
1. Disconnect the battery ground cable.
2. Remove the ignition switch lock cylinder.
1
Insert the ignition key into the ignition switch lock cylinder and turn to the RUN position.
2
Insert a punch through the hole in the lower steering column shroud and push the ignition switch lock cylinder release tab while pulling out the
ignition switch lock cylinder.
3. NOTE: The steering wheel is removed for clarity.
If equipped, twist the tilt wheel handle and shank and remove.
4. Remove the upper and lower steering column shrouds.
1
Remove the screws.
2
Remove the lower steering column shroud.
3
Remove the upper steering column shroud.
