E 150 V8-4.6L SOHC VIN W (2004)
4. Using the special tool, disconnect the tie-rod end.
5. Remove and discard the cotter pin and the nut.
6. Remove the pinch bolt adjuster.
7. CAUTION: To prevent damage to the ball joint seal and the ball joint socket, do not use a pickle fork-type remover to loosen the ball joints.
Remove the front wheel spindle.
1
Strike the lower end of the front axle to loosen the ball joint.
2
Remove the front wheel spindle.
8. To install, reverse the removal procedure.
^
Check and, if necessary, align the front end.
