E 150 V8-4.6L VIN W (2006)
Removal and Installation
WARNING: Use of any other than approved DOT 3 motor vehicle brake fluid will cause permanent damage to brake components and will
render the brakes inoperative. Failure to follow these instructions may result in personal injury.
WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If
brake fluid contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If taken internally, drink
water and induce vomiting. Get medical attention immediately. Failure to follow these instructions may result in personal injury.
CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with
water.
All vehicles
1. Disconnect the battery ground cable. For additional information, refer to Battery.
2. Remove the 3 bolts and position the degas bottle aside.
^
To install, tighten to 10 Nm (89 inch lbs.).
Vehicles with 6.0L engine
3. NOTE: Do not disconnect the hoses from the power steering fluid reservoir.
Remove the 4 bolts and position the power steering fluid reservoir and bracket aside.
^
To install, tighten to 28 Nm (21 ft. lbs.).
Vehicles with 4.6L, 5.4L or 6.0L engines
4. Detach the power steering fluid reservoir and position the reservoir aside.
All vehicles
5. Disconnect the brake tube fittings from the brake master cylinder.
^
To install, tighten to 19 Nm (14 ft. lbs.).
