E 150 V8-4.6L VIN W (2006)
3. Drain the engine oil.
4. Disconnect the 2 coolant hoses from the oil cooler.
5. Remove and discard the oil filter.
6. CAUTION: If metal or aluminum debris is present in the oil cooler, mechanical concerns exist.
Remove the threaded insert and discard the oil cooler.
Installation
1. NOTE: Make sure the tab on the oil filter adapter nests into the notch in the oil cooler.
Position a new oil cooler on the oil filter adapter and install the threaded insert.
^
Tighten to 58 Nm (43 ft. lbs.).
2. Install a new oil filter.
^
Tighten to 16 Nm (12 ft. lbs.).
3. Connect the 2 coolant hoses to the oil cooler.
4. Install the oil drain plug.
^
Tighten to 14 Nm (10 ft. lbs.).
5. Fill the engine with clean engine oil.
6. Fill and bleed the engine cooling system. For additional information, refer to Cooling System.
