E 150 V8-4.6L VIN W (2006)
5.4L engines
2. Position the oil filter adapter gasket and the oil filter adapter. Install the nut and bolts.
^
Tighten the front nuts and bolts to 25 Nm (18 ft. lbs.).
^
Tighten the rear bolt to 48 Nm (35 ft. lbs.).
4. Install the EOP sensor.
^
Tighten to 14 Nm (10 ft. lbs.).
5. Connect the EOP sensor electrical connector.
6. Install the drain plug.
^
Tighten to 14 Nm (10 ft. lbs.).
7. Install the LH engine support insulator.
8. Install the oil cooler.
9. Fill the engine with clean engine oil.
10. Connect the battery ground cable. For additional information, refer to Battery.
