E 150 V8-4.6L VIN W (2006)
7. Allow the upper and lower intake manifolds to dry completely.
Assembly
1. Position a new lower intake manifold gasket and the upper intake manifold on the lower intake manifold and loosely install the bolts.
2. Tighten the bolts in 2 stages using the sequence shown.
^
Stage 1: Tighten to 2 Nm (18 inch lbs.).
^
Stage 2: Tighten to 10 Nm (89 inch lbs.).
3. NOTE: Lubricate the new O-ring seals with clean engine oil prior to installation.
Using new O-ring seals, install the fuel injectors into the fuel rail.
4. Position the fuel rail and install the 4 bolts.
^
Tighten to 10 Nm (89 inch lbs.).
