E 150 V8-4.6L VIN W (2006)
Windsor engine (5.4L)
4. Tighten the engine front cover fasteners in sequence in 3 stages.
Stage 1: Tighten fasteners 1 through 5 to 25 Nm (18 ft. lbs.).
Stage 2: Tighten fasteners 6 and 7 to 48 Nm (35 ft. lbs.).
Stage 3: Tighten fasteners 8 through 15 to 48 Nm (35 ft. lbs.).
All engines
5. Loosely install the bolts, then tighten the bolts in 2 stages following the sequence shown.
^
Stage 1: Tighten to 20 Nm (15 ft. lbs.).
^
Stage 2: Tighten an additional 60 degrees.
6. Lubricate the engine front cover and the crankshaft front seal inner lip with clean engine oil.
7. Using the special tools, install a new crankshaft front seal.