E 150 V8-4.6L VIN W (2006)
Seat Belt: Service and Repair
Safety Belt - Rear 3-Passenger Bench Seat
SAFETY BELT - REAR 3-PASSENGER BENCH SEAT
Removal and Installation
WARNING: All safety belt assemblies (including retractors, belt tension sensors [BTS] if equipped, buckles, shoulder belt height adjusters, [if
so equipped], child safety seat tether attachments and attaching hardware) should be inspected after any collision. All new belt assemblies
should be installed unless a qualified technician finds the assemblies show no damage and operate correctly. Belt assemblies not in use during a
collision should also be inspected and new assemblies installed if either damage or incorrect operation is noted.
NOTE: LH side shown, RH side similar.
1. Remove the bolt and the LH rear safety belt buckle assembly.
-
To install, tighten to 40 Nm (30 lb-ft).
2. Remove the bolt and the RH rear safety belt buckle and tongue assembly.
-
To install, tighten to 40 Nm (30 lb-ft).
3. NOTE: Make sure the safety belt webbing is not twisted prior to installation.
To install, reverse the removal procedure.
4. Check the active restraint system for correct operation.