E 150 V8-4.6L VIN W (2006)
2. Remove the nut and the D-ring.
1
To install, tighten to 40 Nm (30 lb-ft).
3. Remove the front door scuff plate.
4. Remove the bolt and the safety belt anchor.
-
To install, tighten to 48 Nm (35 lb-ft).
Driver side retractor
5. Remove the body side trim finish panel, the front upper body side trim panel and the front lower side trim panel.
Passenger side retractor
6. Remove the center body pillar upper trim panel and the center body lower trim panel.
7. Remove the bolt and the safety belt retractor.
-
To install, tighten to 48 Nm (35 lb-ft).
All front retractors
8. NOTE: Make sure the safety belt webbing is not twisted prior to installation.
To install, reverse the removal procedure.
9. Check the active restraint system for correct operation.
