E 150 V8-4.6L VIN W (2006)
Open the safety belt shoulder guide cover.
2. Remove the bolt and the safety belt shoulder guide.
-
To install, tighten to 40 Nm (30 lb-ft).
3. Remove the body side trim finish panel.
4. Remove the rear safety belt shoulder strap opening covers.
5. Detach the secondary safety belt shoulder guide.
6. Remove the bolt and the safety belt retractor.
-
To install, tighten to 40 Nm (30 lb-ft).
Passenger side second, third, fourth and fifth (if equipped) row retractors
7. NOTE: Inspect the safety belt shoulder guide cover for damage. If the cover is damaged install a new cover.
Open or position aside the safety belt shoulder guide cover.
8. Remove the bolt and the safety belt shoulder guide.
-
To install, tighten to 40 Nm (30 lb-ft).
9. Remove the quarter trim upper panel, the quarter trim lower panel, the quarter trim rear upper panel and the body side trim cover panel.
10. Detach the secondary safety belt guide (if equipped).
11. Remove the bolt and the safety belt retractor.
-
To install, tighten to 40 Nm (30 lb-ft).
Driver side third, fourth and fifth (if equipped) row retractors
12. Position the safety belt shoulder guide cover aside and remove the safety belt guide bolt.
-
To install, tighten to 40 Nm (30 lb-ft).
13. Remove the upper and lower quarter trim panels.
14. Remove the lower safety belt shoulder guide.
15. Remove the bolt and the safety belt retractor.
-
To install, tighten to 40 Nm (30 lb-ft).
All Retractors
16. NOTE: Make sure the safety belt webbing is not twisted prior to installation.
To install, reverse the removal procedure.
17. Check the active restraint system for correct operation.