E 150 V8-4.6L VIN W (2006)
Axle Beam: Service and Repair
Axle
Removal
CAUTION: Suspension fasteners are critical parts because they affect performance of vital parts and systems and their failure can result in major
service expense. A new part with the same part number must be installed if installation becomes necessary. Do not use a replacement part of lesser
quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct retention of these parts.
1. Remove the wheel spindle.
2. Remove the radius arm.
3. NOTE: In order to obtain clearance for the pivot bolt removal when servicing the RH front axle, it may be necessary to raise the LH side of the
vehicle to relieve the weight on the suspension.
Remove and discard the pivot nut and bolt and remove the axle.
Installation
1. NOTE: Do not tighten the nut at this time.
Position the axle and install a new pivot bolt and nut.
2. Install the radius arm.
3. Install the wheel spindle.
4. With the weight of the vehicle on the wheels, tighten the axle pivot nut to 176 Nm (130 ft. lbs.).
5. Check and, if necessary, align the front end.
