E 150 V8-4.6L VIN W (2006)
1
Disconnect the transmission shift cable from the steering column shift tube lever.
2
Carefully lift the locking tab and disconnect the transmission shift cable from the steering column bracket.
2. Disconnect the cable push pin from the stud in the bulkhead.
3. Push the rubber grommet and transmission shift cable through the bulkhead.
4. Raise and support the vehicle.
5. NOTE: To prevent shift cable assembly damage, do not apply force to the transmission shift cable between the manual control lever and the
transmission shift cable bracket.
Remove the transmission shift cable from the transmission.
^
Disconnect the transmission shift cable from the manual control lever.
6. Remove the shift cable bracket from the transmission.
^
Remove the bolts.
^
To install, tighten to 48 Nm (35 ft. lbs.).
7. To install, reverse the removal procedure.
^
Adjust the shift cable.
