E 150 V8-4.6L VIN W (2006)
5. Install the center bearing bracket bolts.
^
Tighten to 63 Nm (46 ft. lbs.).
6. Install the rear driveshaft section.
7. CAUTION: Install the driveshaft with new bolts. If new bolts are not available, apply sealer to the threads of the original bolts.
CAUTION: The driveshaft flange yoke fits tightly on the pinion flange pilot. To make sure that the yoke seats squarely on the flange, tighten the
bolts evenly in a cross pattern in the sequence shown.
Position the driveshaft flange yoke on the pinion flange with the index marks aligned and install the driveshaft-to-pinion flange bolts.
^
Tighten to 112 Nm (83 ft. lbs.).
