E 150 V8-5.4L (2008)
Keyless Entry Transmitter: Testing and Inspection
Remote Keyless Entry Transmitter Programming
REMOTE KEYLESS ENTRY TRANSMITTER PROGRAMMING
CAUTION: All remote keyless entry (RKE) transmitters must be programmed at the same time.
1. Before entering the program mode, the vehicle must be electronically unlocked with the RKE transmitter or the door lock control switch while the
driver door is open.
2. Turn the ignition switch from OFF to RUN 8 times within 10 seconds, with the eighth turn ending in RUN. If the module has successfully entered
program mode, it locks and then unlocks all the doors.
3. Within 20 seconds, press any button on a RKE transmitter and the doors lock and then unlock to confirm that each remote transmitter has been
programmed. Repeat this step for each RKE transmitter.
4. If the door locks do not respond for any RKE transmitter, wait several seconds and press the button again. If the door locks still fail to respond,
refer to Inspection and Verification. Make sure that no more than the maximum number of RKE transmitters are being programmed.
5. Exiting the programming mode is accomplished if 1 of the following occurs:
-
The key transitions to the OFF position.
-
20 seconds have passed since entering programming mode or since the last RKE transmitter was programmed.
-
The maximum number of RKE transmitters have been programmed.
