E 150 V8-5.4L (2008)
Removal and Installation
WARNING: Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that
has been previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of
serious personal injury.
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice.
In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety
Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.
CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash
it with water.
1. Release the wheel speed sensor wiring harness from the brake flexible hose.
2. Remove the brake caliper flow bolt and discard the 2 copper washers.
^
To install, tighten bolt to 40 Nm (30 lb-ft).
^
Use new copper washers.
3. Disconnect the brake tube fitting from the brake flexible hose.
^
To install, tighten to 17 Nm (13 lb-ft).
4. Remove the brake flexible hose retaining clip and the brake flexible hose.
5. To install reverse the removal procedure.
^
Bleed the brake caliper.
