E 150 V8-5.4L (2008)
6. Remove the hood release handle bezel from the LH A-pillar lower trim panel, then remove the LH A-pillar lower trim panel.
7. Disconnect the electrical connector from the parking brake switch.
8. Remove the 3 parking brake control nuts and position the parking brake control to access the front parking brake cable.
^
To install, tighten to 23 Nm (17 lb-ft).
9. Disconnect the front cable from the parking brake control.
10. Disconnect the front parking brake cable conduit from the parking brake control.
1
Using a box-end wrench, compress the fingers of the parking brake cable conduit.
2
Remove the front parking brake cable and conduit from the parking brake control.
11. To install, reverse the removal procedure.