E 150 V8-5.4L (2008)
9. Support the rear of the transmission with a safety stand.
10. NOTE: RH shown, LH similar.
Remove the RH and LH transmission crossmember-to-frame nuts and bolts and remove the transmission crossmember.
^
To install, tighten to 81 Nm (60 lb-ft).
11. Remove the 4 exhaust Y-pipe-to-exhaust manifold nuts and discard. Remove the exhaust Y-pipe.
^
To install, tighten the new upper exhaust Y-pipe-to-exhaust manifold nuts to 40 Nm (30 lb-ft) then tighten the new lower exhaust
Y-pipe-to-exhaust manifold nuts to 40 Nm (30 lb-ft).
12. To install, reverse the removal procedure.
