E 150 V8-5.4L (2008)
Hose/Line HVAC: Service and Repair
Compressor to Condenser Discharge Line
COMPRESSOR TO CONDENSER DISCHARGE LINE
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Recover the refrigerant.
3. Remove the RH front wheel and tire.
4. Remove the A/C compressor discharge fitting nut and disconnect the fitting.
-
Discard the O-ring seal and gasket seal.
-
To install, tighten to 15 Nm (11 lb-ft).
5. Disconnect the high-pressure cutoff switch electrical connector.
6. Remove the condenser inlet fitting nut and disconnect the fitting.
-
Discard the O-ring seal and gasket seal.
-
To install, tighten to 15 Nm (11 lb-ft).
7. Remove the compressor-to-condenser discharge line.
8. To install, reverse the removal procedure.
-
Install new gasket seals and O-ring seals.
-
Lubricate the refrigerant system with the correct amount of clean PAG oil.
9. Evacuate, leak test and charge the refrigerant system.
