E 150 V8-5.4L (2008)
Midship Fuel Tank (Part 2)
Removal and Installation
WARNING:
-
When working on or near the evaporative emission (EVAP) system, disconnect the battery ground cable from the battery. The EVAP
system contains fuel vapor and condensed fuel vapor, so an electrical spark may cause a fire or explosion. Failure to follow this
instruction may result in serious personal injury.
-
Do not smoke, carry lighted tobacco or have an open flame of any type when working on or near any fuel-related component. Highly
flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
NOTE:
-
Midship fuel tank evaporative emission (EVAP) canister shown, aft-of-axle fuel tank EVAP canister similar.
-
Some aft-of-axle fuel tank EVAP canister assemblies do not have a EVAP canister vent solenoid. The EVAP canister vent solenoid is replaced
with a vapor hose.
All vehicles
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the battery ground cable.
3. Remove the spare tire.
4. Disconnect the fuel vapor vent hose and fuel vapor tube-to-EVAP canister quick connect coupling.
5. Disconnect the EVAP canister vent solenoid electrical connector and harness retainer.
