E 150 V8-5.4L (2008)
Removal and Installation
NOTE: The condenser-to-evaporator line for vehicles equipped with auxiliary climate control is supplied as an assembly with the auxiliary suction line.
Vehicles with auxiliary climate control
1. With the vehicle in NEUTRAL position it on a hoist.
Vehicles with 4.6L, 5.4L or 6.8L engine
2. Remove the engine air cleaner and the air cleaner outlet tube.
All vehicles
3. Recover the refrigerant.
4. Remove the condenser outlet fitting nut and disconnect the fitting.
-
Discard the O-ring seal and gasket seal.
-
To install, tighten to 15 Nm (11 lb-ft).
5. Remove the evaporator inlet fitting bracket screw.
-
To install, tighten to 2 Nm (18 lb-in).
6. CAUTION: Use a wrench on each side of the air conditioning (A/C) fitting to prevent damage to the fitting.
Disconnect the evaporator inlet fitting.
