E 150 V8-5.4L (2008)
6. Disconnect the A/C compressor electrical connector.
7. NOTE: It is not necessary to remove the A/C compressor bolts.
Loosen the bolts enough to slide the A/C compressor down 25.4 mm (1 in), allowing access for CKP sensor removal.
-
To install, tighten to 25 Nm (18 lb-ft).
8. Remove the CKP sensor bolt and the CKP sensor. Inspect the O-ring seal for damage and replace if necessary.
-
Lubricate the O-ring seal with clean engine oil prior to installation.
-
To install, tighten to 10 Nm (89 lb-in).
9. To install, reverse the removal procedure.
