E 150 V8-5.4L (2008)
2. NOTE: Make sure the fuel tube clicks into place when installing the tube. To make sure that the fuel tube is fully seated, pull on the tube.
Apply clean engine oil to O-ring seals.
Fit the male end into the female end and push until the garter spring snaps over the flared end of the female end.
3. Make sure the spring lock coupling is engaged by pulling on the tube.
4. Install the safety clip.
Disconnect - Type II
WARNING:
-
Do not smoke, carry lighted tobacco or have an open flame of any type when working on or near any fuel-related component. Highly
flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
