E 150 V8-5.4L (2008)
Fuel Pump Control Unit: Service and Repair
FUEL PUMP DRIVER MODULE (FPDM)
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. NOTE: The fuel pump driver module (FPDM) is mounted to the left inside frame rail.
Disconnect the FPDM electrical connector.
3. Remove the 2 retaining nuts and FPDM.
-
To install, tighten to 10 Nm (89 lb-in).
4. To install, reverse the removal procedure.
