E 150 V8-5.4L (2008)
NOTE: Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic
procedure again.
All safety belt retractors
1. NOTE: Inspect the D-ring cover for damage. If damaged or does not remain attached, install a new D-ring cover.
Remove the D-ring cover.
2. Remove the bolt and D-ring.
-
To install, tighten to 40 Nm (30 lb-ft).
LH safety belt retractor
3. Remove the LH quarter trim finish panel, upper rear quarter trim panel and lower rear quarter trim panel.
All safety belt retractors
4. Remove the bolt and safety belt anchor from the floor.
-
To install, tighten to 40 Nm (30 lb-ft).
5. Remove the bolt and the safety belt retractor.
-
To install, tighten to 40 Nm (30 lb-ft).
6. NOTE: Make sure the safety belt webbing is not twisted prior to installation.
To install, reverse the removal procedure.
7. Check the active restraint system for correct operation.
Safety Belt Retractor - Fourth Row, Outboard
SAFETY BELT RETRACTOR - FOURTH ROW, OUTBOARD
Exploded View
