E 150 V8-5.4L (2008)
Cross-Member: Service and Repair
Transmission Support Crossmember
Transmission Support Crossmember
Removal and Installation
1. Secure a suitable transmission jack to the transmission.
2. Disconnect the wiring harness from the crossmember, if equipped.
3. Remove the transmission mount insulator nuts.
-
To install, tighten to 94 Nm (69 lb-ft).
4. Remove the heat shield-to-crossmember bolts.
5. Remove the RH crossmember nuts.
-
To install, tighten to 81 Nm (60 lb-ft).