E 150 V8-5.4L (2008)
4. NOTE: To prevent selector lever cable damage, do not apply force to the selector lever cable assembly between the steering column shift tube
bracket and the steering column bracket.
Disconnect the selector lever cable from the steering column.
1) Disconnect the selector lever cable from the steering column shift tube lever.
2) Carefully lift the locking tab and disconnect the selector lever cable from the steering column bracket.
5. Disconnect the cable pushpin from the stud in the bulkhead.
6. Push the rubber grommet and transmission selector lever cable through the bulkhead.
7. Remove the selector lever cable and bracket from the transmission.
1) Disconnect the selector lever cable from the manual control lever.
2) Disconnect the wire harness from the selector lever cable bracket.
3) Remove the bolts and position the selector lever cable and bracket aside.
^
To install, tighten to 48 Nm (35 lb-ft).
8. NOTE: When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place and the selector lever
cable end is snapped onto the ball stud. Press the selector lever cable into the selector lever cable bracket and listen for the cable to click into
place. Pull back on the selector lever cable to make sure that it is locked into the selector lever cable bracket. Also, make sure that the selector
lever cable end is correctly installed onto the ball stud. Pull back on the selector lever cable to make sure that the selector lever cable end is
correctly installed.
To install, reverse the removal procedure.
