E 150 V8-5.4L (2008)
4. Install the transmission fluid cooler tube rear bracket.
^
Tighten to 48 Nm (35 lb-ft).
Gas engine vehicles
5. Install the transmission fluid cooler tubes into the vehicle.
6. Reposition the starter motor electrical harness to the rear of the vehicle and connect the pushpin.
7. Connect the starter motor electrical connections.
^
Tighten the ground cable to 20 Nm (15 lb-ft).
^
Tighten the battery cable to 12 Nm (9 lb-ft).
^
Tighten solenoid wire to 6 Nm (53 lb-inch).
