E 150 1/2 Ton Van V6-4.2L VIN 2 (1997)
Disc Brake Specifications
INSTALLATION:
1. If the brake shoes and linings were changed, resurface the front disc brake rotor.
NOTE: If the brake shoes and linings were changed, the front disc brake rotor must be resurfaced. Ford recommends on-vehicle rotor machining.
2. If installing new brake pads, use a C-clamp and a brake pad to press the caliper piston to the bottom of the caliper bore.
NOTE:
^
Bottoming of the caliper piston is not necessary if reusing the original brake pads.
3. Fill the rubber caliper sleeve boots with Silicone Brake Caliper Grease and Dielectric Compound D7AZ-19A331-A (Motorcraft WA-10) or en
equivalent silicone compound meeting Ford specification ESE-M1C171-A.
CAUTION: To prevent deterioration of the caliper sleeve boots, do not use petroleum-based lubricant.
Brake Caliper And Front Brake Hose
