E 150 1/2 Ton Van V6-4.2L VIN 2 (1997)
13. Remove the water pump mounting studs. Discard the studs.
14. Remove the engine front cover and the engine front cover gasket. Discard the gasket.
15. Clean the mating surfaces on the oil pan and the cylinder block. Use Metal Parts Cleaner F4AZ-19A536-RA or equivalent meeting Ford
specification WSE-M5B292-A.
NOTE: When cleaning, use care to prevent debris from falling into the oil pan.
INSTALLATION
1. Install the engine front cover.
^
Apply a bead of Silicone Gasket and Sealant F6AZ-19562-A or equivalent meeting Ford specification WSE-M4G323-A1 at the oil pan to
block seam.
^
Install the engine front cover gasket.
^
Apply a second bead of sealant along the edge of the engine front cover gasket at the oil pan to block seam.
^
Apply a bead of sealant on the oil pan flange.
^
Install the front cover. Position the lower edge of the cover on the oil pan and tip upward into position.
NOTE: If the oil pan and rear oil seal are not installed within seven minutes, remove sealant and reapply.
