E 150 1/2 Ton Van V6-4.2L VIN 2 (1997)
Impact Sensor: Service and Repair
REMOVAL
1. Disconnect the battery ground cable. On vehicles equipped with auxiliary batteries:
-
Disconnect primary battery ground cable.
-
Disconnect auxiliary battery frame ground bolt. Pull cable away from the frame and make sure cable does not contact frame.
NOTE: Failure to accurately follow the battery disconnect procedures will result in vehicle or component damage.
NOTE: When the battery has been disconnected and reconnected, some abnormal drive symptoms may occur while the Powertrain Control
Module (PCM) relearns its adaptive strategy. The vehicle may need to be driven 16 km (10 miles) or more to relearn the strategy.
2. Remove the radiator grille.
3. Disconnect the primary crash sensor electrical connector.
4. Remove the primary crash sensor.
1
Remove the screws.
2
Remove the primary crash sensor.
INSTALLATION
1. Follow the removal procedure in reverse order.
2. Reconnect negative battery ground cable. On vehicles equipped with auxiliary batteries:
-
Reconnect the auxiliary battery frame ground.
-
Reconnect the primary battery ground cable.
