E 150 1/2 Ton Van V6-4.2L VIN 2 (1997)
Air Bag Control Module: Service and Repair
REMOVAL
1. Disconnect the battery ground cable. On vehicles equipped with auxiliary batteries:
-
Disconnect primary battery ground cable.
-
Disconnect auxiliary battery frame ground bolt. Pull cable away from the frame and make sure cable does not contact frame.
NOTE: Failure to accurately follow the battery disconnect procedures will result in vehicle or component damage.
NOTE: When the battery has been disconnected and reconnected, some abnormal drive symptoms may occur while the Powertrain Control
Module (PCM) relearns its adaptive strategy. The vehicle may need to be driven 16 km (10 miles) or more to relearn the strategy.
CAUTION: Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage can result.
2. Remove the RH cowl side trim panel.
3. Disconnect the air bag Electronic Crash Sensor (ECS) module electrical connector.
1
Disconnect the ECS electrical connector locking clip.
2
Disconnect the ECS electrical connector.
4. Remove the air bag ECS module.
1
Remove the ECS module retaining bolts.
2
Remove the ECS module.
INSTALLATION
1. Follow the removal procedure in reverse order.
2. Reconnect negative battery ground cable. On vehicles equipped with auxiliary batteries: