E 150 1/2 Ton Van V6-4.2L VIN 2 (1997)
1
Remove the B+ terminal nut and disengage the wire.
2
Remove the enable nut and disengage the wire.
3
Remove the ground nut and disengage the wire.
9. Disengage the three engine splash shield plastic clips and remove the engine splash shield.
10. Remove the transmission cooler line/primary battery cable bracket nut.
11. Pull the primary battery cable assembly through the engine support crossmember under the vehicle.
12. Disengage the harness locator, located below the battery tray mounts.
13. Pull the primary battery cable assembly out of the vehicle from the engine compartment.
INSTALLATION
