E 150 1/2 Ton Van V6-4.2L VIN 2 (1997)
Alternator Brush: Service and Repair
REMOVAL
1. Remove the generator.
2. Remove the generator brush and terminal holder and the voltage regulator.
1
Remove the four voltage regulator screws.
2
Remove the generator brush and terminal holder and the voltage regulator.
3. Separate the generator brush and terminal holder from the voltage regulator.
1
Remove the screw cap.
2
Remove the two generator brush and terminal holder screws.
3
Separate the generator brush and terminal holder from the voltage regulator.
INSTALLATION
1. Install the brush and terminal holder on the voltage regulator.
1
Position the brush and terminal holder on the voltage regulator.
2
Install the two generator brush and terminal holder screws.
3
Install the screw cap.
CAUTION: Make sure screw cap is installed over Test Terminal A to prevent accidental shorting of the battery positive connection.