E 150 1/2 Ton Van V6-4.2L VIN 2 (1997)
Alignment: Service and Repair
Toe
1. Remove the horn pad and make sure the steering wheel is correctly installed.
2. Using an alignment rack and the manufacturer's instructions, check the vehicle toe. Refer to Alignment Specifications to determine the amount of
correction required.
3. Raise and support the vehicle.
4. Loosen the clamp nuts on the adjusting sleeves at each side of the vehicle.
5. Rotate the adjusting sleeves to obtain the correct toe setting.
6. Tighten the RH adjusting sleeve clamp nuts.
CAUTION: The RH adjusting sleeve clamp opening must face downward and be within 45 degrees of vertical.
7. Tighten the LH adjusting sleeve clamp nuts.
CAUTION: The LH adjusting sleeve clamp opening must face upward and be within 45 degrees of vertical.
8. Recheck the toe to make sure setting was not altered when the adjusting sleeve clamps were tightened.
