E 150 1/2 Ton Van V6-4.2L VIN 2 (1997)
13. Use Adjuster and Locknut Wrench to tighten the power steering gear race nut.
14. Install the steering gear Allen head race lock nut.
15. Remove the valve housing from Bench Mounted Holding Fixture and position the piston on the input shaft valve.
16. Install the (B) steering gear ball return guide on the (A) piston.
WARNING: HOLD THE BALL RETURN GUIDES UNTIL THE CAP OR CLIP IS REINSTALLED. FAILURE TO HOLD THE
GUIDES WILL RESULT IN A TRAPPED BALL OR BALLS, WHICH CAN CAUSE A VEHICLE ACCIDENT. IF THE BALL
GUIDES BECOME UNSEATED AT ANY TIME, REMOVE ALL THE BALLS AND REPEAT THE PROCEDURE.
