E 150 1/2 Ton Van V6-4.2L VIN 2 (1997)
2. Set the housing flat on a workbench and tap the steering column bearing loose with a suitable plastic drift and a rubber hammer.
INSTALLATION
1. Support the lock cylinder housing on a workbench.
2. Position the steering column bearing so the inner race will face up and fully visible, or out from the lock cylinder housing when installed.
3. Install the lock cylinder.
4. Using a socket or bushing driver the same size as outer race of the steering column bearing, tap the steering column bearing into the housing with a
plastic hammer until fully seated.
Lower
REMOVAL
1. Support the steering actuator housing on a workbench.