E 150 1/2 Ton Van V6-4.2L VIN 2 (1997)
INSTALLATION
1. Install the (A) tie rod end into the (B) tie rod adjusting sleeve clamp with the same number of turns as required for removal, then tighten the (C) tie
rod end adjusting sleeve clamp bolts.
NOTE: The two bolts and nuts on the tie rod adjusting sleeve clamp for the tie rod end must be positioned within a limit of 45 degrees (+). The
threaded ends of the bolts on the left tie rod end point toward the front of the vehicle. The threaded ends of the bolts on the right tie rod end face
rearward.
2. Install the castle nut and a new cotter pin.
NOTE: Make sure the ball stud is seated in the taper, to prevent rotation while tightening.
3. Check toe-in and clear vision.
