E 150 1/2 Ton Van V6-4.2L VIN 2 (1997)
Valve Body: Service and Repair
Removal and Installation
REMOVAL
1. Disconnect the battery.
WARNING: On vehicles equipped with an auxiliary battery, both the negative and positive battery cables must be disconnected.
2. Raise and support the vehicle.
3. Drain the transmission fluid. Remove the transmission fluid pan, filter and seal.
4. Disconnect the solenoid and sensor electrical connectors.
(1) Transmission Fluid Temperature (TFT) sensor.
(2) Shift solenoids SS1 and SS2.
(3) Torque Converter Clutch (TCC) solenoid.
(4) Electronic Pressure Control (EPC) solenoid.
CAUTION: Do not pull on the wires. This can damage the wires or the connector and can result in transmission solenoid or sensor failure.
Carefully pry up on the locking tab and disconnect the connector.
5. Remove the manual valve detent spring.
(1) Remove the bolt.
(2) Remove the manual valve detent spring.
