E 150 1/2 Ton Van V6-4.2L VIN 2 (1997)
6. Rotate the gauge block several half-turns to ensure proper seating of the pinion bearings and position the gauge block.
NOTE:The gauge block must be offset to obtain an accurate reading.
7. Install the Gauge Tube.
(1) Position the gauge tube.
(2) Install the differential side bearing caps.
(3) Install the four differential side bearing cap bolts.
8. Use a drive pinion bearing adjustment shim as a gauge for shim selection.
NOTE:
-
Drive pinion bearing adjustment shims must be flat and clean.
-
A slight drag should be felt for correct shim selection. Do not attempt to force the pinion shim between the gauge block and the gauge tube.
This will minimize selection of a pinion shim thicker than required, which results in a deep tooth contact in final assembly of integral rear
axle assemblies.
