E 150 Van V8-351 5.8L VIN G 2-bbl (1984)
FIGURE 4
Remove the heat shields covering the muffler by removing the retaining clamps securing the shields as shown in Figure 3. If the muffler is a non-Ford
design or is a non-ribbed design (Figure 4), remove the Muffler and Outlet Pipe Assembly and replace with the heavy duty ribbed muffler assembly as
indicated in the attached chart.
If the muffler is the heavy duty type (ribbed design - Figure 4), installed during the 1987 M53 recall, inspect the entire surface of the muffler for cracks
or openings. If any such openings are found, replace the Muffler and Outet Pips Assembly with a new heavy duty ribbed muffler assembly. Advise the
Ambulance Technical Hot Line 1-800-445-1571, if you find a ribbed muffler with cracks or openings.
FIGURE 2
If the unit is not equipped with the all-steel hangers as shown in Figure 2, order and install the Ford Service Part as indicated in the attached chart.
ATTACHMENT III EXHIBIT 1 PAGE 3 OF 3
SPECIFIC TECHNICAL REPAIR CODE AND PARTS ORDERING INSTRUCTIONS
