E 150 Van V8-351 5.8L VIN G 2-bbl (1984)
Drive/Propeller Shaft: All Technical Service Bulletins
Driveshaft - Graphite Composition
Article No. 84-19-22
DRIVESHAFT - GRAPHITE COMPOSITION
LIGHT TRUCKS 1984-1/2 E250-350
A new one-piece graphite driveshaft will replace the current two-piece steel driveshafts on a limited number of vehicles with a 4.10 axle ratio beginning
approximately June 18, 1984.
The graphite driveshaft can be distinguished by its large 4" diameter, fiberglass appearance and riveted construction. N.V.H. characterstics are improved
by the damping properties of the material.
Graphite driveshafts are serviced in the same manner as conventional steel driveshafts with regard to universal joint/slip yoke replacement and balance.
Service graphite driveshaft assemblies will not be available until 1985 model year. If replacement is necessary, a two-piece driveline must be installed. A
one-piece steel driveshaft must not be installed as it is not structurally equivalent to the graphite shaft. When mounting the center bearing support plate,
the mounting holes in the plate and crossmember must be enlarged to 7/16" to accomodate the mounting bolts.
PART NUMBER
PART NAME
CLASS
D9TZ-4817-AM
Coupling Shaft
CG
E2UZ-4602-A
Driveshaft
RM
E3UZ-4831-A
Center Support Plate
C
56761-S2
Bolt
S
388255-S2
U-Clip
SG
58654-S2
Bolt
S
380079-S2
Washer
S
34988-S100
Nut
BS
OTHER APPLICABLE ARTICLES: 83-19-15
WARRANTY STATUS: Reimbursable within the provisions of the Warranty and Policy Manual.
OPERATION: SP4602A84
TIME:
1.1 Hrs. DLR. CODING: Basic Part No. 4602 Code: As required
