E 250 V10-6.8L VIN S (2005)
11. Remove the nut and front safety belt guide.
12. Remove the front upper body side trim panel.
1
Remove the screws.
2
Remove the front upper trim panel from the body side.
13. Remove the front lower body side trim panel.
1
Remove the screw.
2
Remove the pin-type retainers.
3
Lift the front upper trim panel slightly upward and remove from the body side.
14. To install, reverse the removal procedure.
-
To install the front upper body side trim panel, start at the lower pillar, then work to the second lower pillar.
-
To install the rear lower body side trim panel, start with the clip to the heater housing, then snap the trim panel into the panel clips.
-
To install the rear upper body side trim panel, start with the rear lower portion of the panel at the pillar.
