E 250 V10-6.8L VIN S (2005)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
Hydraulic Control Unit (HCU)
Removal and Installation
WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If
brake fluid contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If taken internally, drink
water and induce vomiting. Get medical attention immediately. Failure to follow these instructions may result in personal injury.
CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with
water.
1. Disconnect the battery.
2. Position the radiator coolant reservoir aside.
1
Remove the bolts.
3. NOTE: Do not disconnect the hose from the power steering pump reservoir.
Remove the bolts and position the power steering pump reservoir aside.
4. Disconnect the brake lines from the brake master cylinder.
5. NOTE: Plug each port of the Hydraulic Control Unit (HCU) to prevent brake fluid from spilling.
