E 250 V10-6.8L VIN S (2005)
9. Remove the A/C clutch field coil.
Installation
1. NOTE: If installing a new A/C compressor, the A/C clutch components should be reused unless obvious signs of damage are found. If excessive
grooving is found, a new A/C clutch disc and hub and A/C compressor pulley must be installed together. Otherwise, each component can be
installed individually where needed.
Visually inspect the A/C clutch disc and hub, A/C compressor pulley and A/C clutch field coil for damage.
-
Inspect for physical damage, including cracked or melted components or discoloration due to excessive heat.
-
Inspect for excessive wear, including grooving in the A/C clutch disc and hub or A/C compressor pulley that is more than fingernail depth.
-
Inspect for roughness in the A/C compressor pulley bearing.
2. Clean the A/C compressor, A/C clutch field coil and the A/C clutch pulley mounting surfaces.
3. CAUTION: There is an indexing locator on the A/C clutch field coil mounting surface. Make sure it is correctly aligned during
installation to the A/C compressor.
Align and install the A/C clutch field coil onto the A/C compressor.
4. Install the A/C clutch field coil snap ring.
