E 250 V10-6.8L VIN S (2005)
-
Discard the O-ring seals.
All vehicles
24. Disconnect the evaporator inlet fitting.
1
Remove the screw.
2
Disconnect the evaporator inlet fitting.
-
Discard the O-ring seal.
25. Remove the screws and the evaporator housing support bracket.
26. Remove the evaporator core cover.
1
Remove the five screws.
2
Remove the four screws.
3
Remove the evaporator core cover.
27. Remove the evaporator core.
28. To install, reverse the removal procedure.
-
Install new O-rings lubricated in clean mineral oil.
-
Lubricate the refrigerant system with the correct amount of clean PAG oil.
29. Evacuate, leak-test and charge the refrigerant system.