E 250 V10-6.8L VIN S (2005)
8. Remove the bolts and separate the rear hub from the rear brake disc.
9. Inspect the rear hub for the following:
^
Cracks and damage around the bolt holes.
^
Oversized holes.
Installation
1. WARNING: Install a new rear hub seal after removing the rear hub from the axle. A damaged or worn seal can permit bearing
lubricant to reach the brake linings, resulting in ineffective brake operation. Failure to follow these instructions may result in personal
injury.
CAUTION: Clean and remove any dirt or foreign material in the rear hub bolt holes.
Install a new rear hub seal.
2. Position the rear brake disc on the rear hub and install the bolts.
3. CAUTION: Thoroughly clean the spindle. Wrap the spindle threads with electrician's tape to prevent damage while installing the rear hub and
brake disc assembly. Lightly coat the spindle and pack each rear wheel bearing with Premium Long-Life Grease XG-1-C or equivalent meeting
Ford specification ESA-M1C75-B.
Prepare the spindle for rear hub installation.
4. Slide the rear hub and brake disc assembly over the axle housing spindle.
^
Remove the electrician's tape.
